The final thing to do is install the end wall trim.
Flashing standing seam roof against side wall.
Metal roofing chimney flashing kit diy video.
This guide is does not cover some aspects of installation.
I understand that the flashing must go under the siding but i am concerned about the workers walking on the metal roof while installing the siding.
I cut the tape so that it laps onto the housewrap above and 3 in.
Flexible flashing tape seals the eave to the wall.
Standing seam trim details a brief guide to the various trims used for standing seam metal roofing as well as how they are installed.
Metal roof flashing is a galvanized sheet metal bent at right angles with about eight to 12 inches on each side of the angle.
Our trim products include angles channels drip cap flashing and more.
The most common flashing for standing seam roofing is the ridge cap which is used at the peak of a roof where two opposing roof slopes join and attaches to the roof with z flashing.
Above the roof sheathing.
Butyl sealant tape or tube sealant should be used under all z channel.
We are planning to put a standing seam metal roof on the porch and the wall will be lap siding.
We have our z trim installed and tape seal on top of the z trim so we can install this and.
Installing the sidewall and endwall at a dormer location.
Standing seam roof trim.
Fabral metal wall and roof systems.
See our installation guide for more info.
The new house we are building has a porch that meets a wall on the second floor.
Since this was an introductory guide to the basics of standing seam metal roof installations we purposefully left out more technical details such as z bar flashing end wall and valley flashing details however they are covered in the video above if you like to learn more about the components that go beyond the basics.
Once the flexible flashing is set i apply a piece of housewrap along the wall where the fascia.
It is commonly used in two story and side split houses.
Other flashings include gable trim which runs up the sloped ends of the roof and drip edge or eave trim.
Before we install the end wall flashing we have to apply tape sealant to the top of the z trim so that there s a water tight barrier between the end wall flashing and the top of the z.
These kinds of houses often have a roof that butts against a wall.
